Opening The Controller; Figure 11. Opening The Controller; Figure 12. Removing The Top Pcb Board - Unitronics Vision 120 OPLC User Manual

Opening the Controller

•
•

Figure 11. Opening the Controller

Figure 12. Removing the Top PCB
Before opening the controller, touch a grounded object to discharge
any electrostatic charge.
Avoid touching the PCB board directly by holding the PCB board by
its connectors.
board
Chapter 5: Communications
1. Turn power off before
opening the controller.
2. Locate the 4 slots on the
sides of the controller.
3. Using the blade of a flat-
bladed screwdriver, gently
pry off the back of the
controller as shown in
Figure 11.
4. Gently remove the top
PCB board:
a. Use one hand to hold the
top-most PCB board by its
top and bottom connectors
as shown in Figure 12.
b. With the other hand, grasp
the controller, while
keeping hold of the serial
ports; this will keep the
bottom board from being
removed together with the
top board.
c. Steadily pull the top board
off.
23