LG B62AWYN9L6 Installation Manual page 45

If pressing button long for 3
1
seconds, it enters into remote
controller setter setup mode.
- If pressing once shortly, it enters
into user setup mode. Please press
more than 3 seconds for sure.
2 If entering into ESP setup mode by using
button, it indicates as the picture
below.
Select ESP fan step by
3
pressing button.
(01: very low, 02: low, 03:
medium, 04: high, 05:
very high)
• When setting ESP value on the product without very weak wind or power wind function, it
may not work.
• Please be careful not to change the ESP value for each fan step.
• It does not work to setup ESP value for very low/power step for some products.
• ESP value is available for specific range belongs to the product.
4
5
(It is possible to setup ESP
value from 1 to 255, and 1 is
the smallest and 255 is the
biggest.)
6
7
ESP step
Function Code ESP value
8
SETTING & TEST
ESP value
Function code,
ESP code
Move to ESP value setting by pressing
button.
(It is 000 when delivering
from the warehouse.)
Press button to setup ESP value.
Select ESP fan step again by using
button and setup ESP value, as No. 4
and 5, that corresponds each wind flow
Press button to save.
Press button to exit.
❈ After setup, it automatically gets out
of setup mode if there is no button
input for 25 seconds.
❈ When exiting without pressing set
button, the manipulated value is not
reflected.
45