Monoprice 34197 User Manual page 8

10. Once you know your installation location is clear, use a drywall or keyhole saw to
cut along the cut lines.
11. If you have not already done so, prepare your speaker wire in accordance with the
guidelines in the Speaker Wire Preparation section above.
Important! Because the speaker wire will necessarily be routed through your walls,
you must use in-wall rated speaker wire.
12. Route your speaker wire from the back of your amplifier, through the wall or space
above the ceiling, to the installation location.
13. If you have not already done so, completely remove the grille, which is held in place
with magnets for ease of removal.
14. Depress the positive/red push terminal on the back of the speaker and insert the
bare wire lead or pin plug on the positive lead into the hole on the side of the
terminal. Release the terminal.
15. Depress the negative/black push terminal and insert the bare wire lead or pin plug
on the negative lead into the hole on the side of the terminal. Release the terminal.
16. Give a gentle tug on each lead to ensure that they are securely connected to the
terminals.
17. Ensure that the mounting tabs on the speaker assembly are turned inwards.
18. Position the speaker into the hole.
19. Using a #2 Phillips screwdriver, tighten each mounting screw to turn the mounting
tabs back outward. Continue tightening until the mounting tabs are firmly against
the back of the wall or ceiling and the speaker is secure. Do not over-tighten the
screws to avoid damage to the mounting tabs.
20. Replace the grille onto the speaker body.
21. Ensure that your amplifier is powered off and unplugged from the power source.
22. Connect the amplifier end of the speaker wire to one of the speaker level outputs
on your amplifier, taking care to match the polarity markings on the speaker wire or
plugs.
Congratulations, your speaker is installed and ready for use!
8