Table of Contents
Advertisement
In many cases, the mark is a single stripe on the jacket of one of the connectors. In this
case the side with the stripe is generally considered the positive side, but it really does not
matter as long as you are consistent and always use the stripe as positive or always use it
as negative.
When you are ready to prepare your speaker
wires, first separate about 4" of wire, then strip
about 1/4" (6mm) insulation from the end and
twist it to prevent stray strands. If you plan to use
banana or pin plugs (highly recommended), install
the plugs on the wire.
PAINTING
The grille and frame can be painted to match your walls or ceiling, making the speaker
even less noticeable. Perform the following steps to safely paint them without damaging
the speaker.
1. Completely remove the grille by
lifting the edge to pull it off the
speaker body.
2. Paint the speaker grille. It is best to
use spray paint to avoid paint
clogging the holes in the grille.
3. Allow the paint to completely dry
before proceeding with installation.
Ensure that the holes in the grille are not blocked by paint.
6
Advertisement
Table of Contents
