Low Voltage Batteries & Manual Override - Motomaster Eliminator 011-1906-4 User's Product Manual

14
model no. 011-1906-4 contact us 1.888.942.6686
•Low Voltage Batteries & Manual Override
:
The jump starter is designed to jump start 12 V lead-acid
batteries down to 2 V. If your battery is below 2 V, the White
LED will be "Off". This is an indication that the jump starter
cannot detect a battery.
If you need to jump start a battery below 2 V there is a
Manual Override feature, which allows you to force "On" the
jump start function.
CAUTION: USE THIS MODE WITH EXTREME CARE.
THIS MODE IS FOR 12 V LEAD-ACID BATTERIES ONLY.
BOTH THE SPARK PROOF AND REVERSE POLARITY
PROTECTION FEATURES ARE DISABLED. PAY VERY
CLOSE ATTENTION TO THE POLARITY OF THE BATTERY
BEFORE USING THIS MODE. DO NOT ALLOW THE
POSITIVE AND NEGATIVE BATTERY CLAMPS TO TOUCH
OR CONNECT TO EACH OTHER AS THE PRODUCT WILL
GENERATE SPARKS. THIS MODE USES VERY HIGH
CURRENT (UP TO 1000 A) THAT CAN CAUSE SPARKS
AND HIGH HEAT IF NOT USED PROPERLY. IF YOU ARE
UNSURE ABOUT USING THIS MODE, DO NOT ATTEMPT
AND SEEK PROFESSIONAL HELP.
Before using the Manual Override feature, make sure the
battery clamps are connected to the correct polarity battery
terminals and the connector is connected to the jump
starter. To use the Manual Override feature, press and hold
the Manual Override Button (a red exclamation point icon
inside a red circle) for three (3) seconds. The White LED
will flash "On" and "Off" indicating you have successfully
entered into Manual Override and it is ready to jump start
your vehicle. If connected in reverse polarity, the Red Error
LED will illuminate and the unit will not operate.
CAUTION: POWER THE JUMP STARTER "OFF" BEFORE
DISCONNECTING THE BATTERY CLAMPS. THIS WILL
ENSURE YOUR SAFETY. REMEMBER BOTH THE
SPARK PROOF AND REVERSE POLARITY PROTECTION
FEATURES ARE DISABLED.