Low Voltage Batteries & Manual Override; Recharging - Motomaster 011-2064-0 Instruction Manual

12
model no. 011-2064-0 | contact us: 1-888-942-6686
Low Voltage Batteries & Manual Override
The unit is designed to jump start 12 Volt lead-acid batteries down to 2 volts.
If your battery is below 2 volts, the display will be off. This is an indicator that
the unit can not detect a battery. If you need to jump start a battery below 2
volts, this unit has an OVERRIDE feature, which allows you to force 'ON' the
jump start function.
CAUTION: Use this mode with extreme care. This mode is for 12 volt
lead-acid batteries only. Both the spark-proof and reverse polarity protection
feature are disabled. Pay very close attention to the polarity of the battery
before using this mode. DO NOT allow the positive and negative battery
clamps to touch or connect to each other as the product will generate
sparks. This mode uses very high current (up to 1000 Amps) that can cause
sparks and high heat if not used properly. If you are unsure about using this
mode, do not attempt and seek professional help.
WARNING! Before using the OVERRIDE mode, ensure the clamps are
connected to the correct polarity (red clamps to POS + terminal of the
battery and black clamp to the NEG – terminal of the battery).
OPERATION
1. Firmly insert the booster clamps into boosting clamps connection port.
2. Press to turn the unit on.
3. Connect red clamp to the POS(+) terminal of the vehicle battery.
4. Connect black clamp to the NEG(-) terminal of the vehicle battery.
OK
Icon will not appears.
13
OK
5. Long Press until the
number 30 appears.
It will icker three times.
6. Try starting the vehicle by cranking the key.
7. Once your vehicle starts, press
battery clamps.
IMPORTANT
The unit must be manual turned off by press
Otherwise it may leads to dangerous situation.

RECHARGING

IMPORTANT!
• Improper charging may result in damage to the unit.
• Ensure that there are no 12 V DC appliances connected to the unit while
being recharged.
• Do not operate any of this unit's functions while charging is in progress.
• Do not recharge the unit while connected to an external battery.
• Recharge battery after each use or at least every 6 months when in storage
to prolong battery life and keep the unit ready for use.
1. Open protective ap to expose USB charging port.
2. Connect micro USB cable to the unit's USB charging port.
3. Connect the other end of the micro USB cable to any powered USB power
port such as a laptop, 12 V DC adaptor (included) or AC charging cube (not
included).
The USB port is rated at 2.4 Amps to ensure safe and ef cient charging of the
internal lithium-ion battery. We recommend that you do not charge and
discharge the unit at same time.
OK
The icon appears and a
countdown begins. You have 30
seconds to jump start your vehicle.
to turn the unit off. Disconnect the
, after manual override.