Bosch AMC2 Installation Manual page 37

AMC2 Modular Controller
The selected display mode remains set until the next time the button is pressed. The order of
the display pages is shown in the following table.
Push
0
1a
1b
2
3
3a
3b
3c
4
5
6
7
8
9
10
11
12
Bosch Access Systems GmbH
Display (Example) Description
V01.00 02.03.07 Software versions and date of
or the firmware - every 5 sec.
LBUS or BG900 alternating with the display of
the reader interface.
S/N1: 0910019212 BOSCH serial number
S/N2: 00000001
02.06 15:35:15 (S) Current date and time
(S) = Summer; (W) = Winter
Dig. IO: :::::::::::::::: Display of the digital contacts:
the input signals set will be
shown with an extension above
- output signals with an
extension below.
Dig. I1: :::::::::::::::: If there are I/O-Boards
connected the signals will be
Dig. I2: ::::::::::::::::
shown on separate pages.
Dig. I3: ::::::::::::::::
MAC 0010174C8A0C Network device address (MAC)
N AMC-1234-5678 Network name of the AMC2
I 192.168.10.18 IP-address of the AMC2
G 192.168.10.255 IP-address of the gateway
(Version V 00.44 or higher)
M 255.255.255.0 Subnetmask
(Version V 00.44 or higher)
H 192.168.10.10 IP-address of the host
computer
DHCP 1 DHCP-status:
1 = on
0 = off
D 192.168.10.1 IP-address of the DNS server
Host: + "C" Host activity:
+ = online
- = offline
"C" = Counter of the received
data packages from the host
interface.
RS 485 Bus connection:
A = Address 1 ... H = Address 8
Installation Manual
Operating | en 37
2018-02 | AMC2-4R4 |