Invacare Orion Series User Manual page 21

Table of Contents

Advertisement

I Low speed mode
J Drive lever
Status Display
The ON/OFF diode (1) is used as a fault display
(status display). It will flash if there is a problem
with the scooter. The number of flashes indicates
the type of error. Refer to 11.1.2 Error Codes And
Diagnostic Codes, page 58.
Battery Indication Gauge
Low battery indication: Every time the scooter is
activated or at work when battery capacity is lower
than 25%, the electronic system will beep three
times.
1603456-D
Fig. 3-2
Overdischarge protection: after a certain drive time
on reserve battery power the electronic system
switches the drive off automatically and brings the
scooter to a standstill. If you do not drive your
scooter for a while the batteries will "recuperate"
and allow a further, but short, journey. However,
after a very brief journey the battery reserve symbol
will illuminate again and the electronic system will
beep three times. This procedure leads to battery
damage and should be avoided if possible!
Reduced driving range.
Battery capacity: <25
Recharge the batteries at the end
%
of your journey.
Battery reserve = severely
Battery capacity: <20
restricted driving range.
%
Recharge batteries immediately!
Fig. 3-3
(2)
(3)
(4)
(5)
(6)
Components
Battery capacity
(7)
(8)
>80 %
<80 %
21

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

OrionproOrionmetro

Table of Contents