Installing Batteries In The Remote Control; Using A Remote Control; The Vcr/Dvd Recorder Switching - Sharp DV-RW340U Operation Manual

Installing batteries in the remote control

Install two "AA" size batteries (supplied) matching
the polarity indicated inside battery compartment of
the remote control.
1
2
Note:
Incorrect use of batteries can result in hazards such
as leakage and bursting. Please observe the following:
• Do not mix new and old batteries together.
• Do not use different kinds of batteries together,
although they may look similar, different batteries
may have different voltages.
• Make sure that the plus and minus ends of each
battery match the indications in the battery com-
partment.
• Remove batteries from equipment that is not going
to be used for a month or more.
• When disposing of used batteries, please comply
with governmental regulations or environmental
public instruction rules that apply in your country
or area.
• Do not recharge, short-circuit, heat, burn or disas-
semble batteries.

The VCR/DVD recorder Switching

Because this product is a combination of a VCR and a DVD recorder, you must select first which com-
ponent you wish to operate with the OUTPUT SELECT button.
VCR MODE
Press the VCR button on the remote control.
(Verify that the VCR indicator is lit.)
DVD MODE
Press the DVD button on the remote control.
(Verify that the DVD indicator is lit.)
Note Note
• Pressing only the OUTPUT SELECT button • Pressing only the OUTPUT SELECT button
on the front panel DOES NOT switch the mode on the front panel DOES NOT switch the mode
of the remote control.You MUST select the cor- of the remote control.You MUST select the cor-
rect mode on the remote control. rect mode on the remote control.
• Pressing the SETUP or the TIMER PROG. • Pressing the SETUP or the TIMER PROG.
button switches the unit to the DVD mode. button switches the unit to the DVD mode.
10
Before you start
Functional overview (cont'd)

Using a remote control

Keep in mind the following when using the remote
control:
• Make sure that there is no obstacle between the
3
• Use within the operating range and angle as
• Remote operation may become unreliable if strong
• Remote control for different devices can interfere
• Replace the batteries when you notice a fall off in
POWER
remote control and the remote sensor of the unit.
shown.
sunlight or fluorescent light is shining on the
remote sensor of the unit.
with each other. Avoid using remote control for
other equipment located close to the unit.
the operating range of the remote control.
Within about
PO WE
R
23feet (7m)
STO
P/EJ ECT
REW
F.FW
D
60˚
Remote
control
OUTPUT SELECT button
OPEN/CLOSE
STOP/EJECT PLAY STOP PLAY
VCR DVD
REW F.FWD REC/OTR REC/OTR
CHANNEL
(TRACKING)
DUBBING OUTPUT SELECT
VCR button
DVD button
VCR DVD
DVD indicator
OUTPUT SELECT
VCR indicator
PLA Y
REC OPE
/OT N/C LOS
R E
CHA VCR
NNE
(TRA L DVD
CKIN G) STO
DUB BIN P
G OUT PLA
PUT Y
SEL ECT
REC /OT
R
REC MODE
POWER OPEN/CLOSE
REC SPEED AUDIO
.@/:
ABC DEF
1 2 3
CH
GHI JKL MNO
4 5 6
PQRS TUV WXYZ VIDEO/TV
7 8 9
SPACE SLOW
0
DISPLAY VCR DVD PAUSE
PLAY
STOP
REC/OTR SETUP TIMER PROG.
ENTER
REC MONITOR
MENU/LIST TOP MENU RETURN
CLEAR/C.RESET ZOOM SKIP SKIP
SEARCH
CM SKIP
MODE
DVD/VCR RECORDER