Basic Conneciton; Easy Connection - Sharp DV-RW2U Operation Manual

Basic Conneciton

Easy Connection

The following connection is the basic connection to watch or record TV programs.
To use cable box or satellite receiver, see "CATV or Satellite Receiver Connec-
tions" on page 21.
Important!
• This recorder is equipped with copy protection technology. The playback
picture from this recorder will not appear correctly on your TV when you
connect this recorder to your TV via a VCR (or your VCR via this recorder) using
Video/Audio cables.
• Be sure to turn off and unplug from the wall outlet this recorder and all
equipments before connecting the cables.
TV
To VIDEO/AUDIO
IN 1 jacks
Video/Audio
cable
To antenna
(Supplied)
input jack
4
VCR
The Recorder
DV_RW2U#p19-23.p65
3
Coaxial cable
(Commercially available)
To antenna
output jack
To antenna
input jack
To OUT TO
TV
COMPONENT
OUT
LINE R-AUDIO-L VIDEO S-VIDEO
(480I/480P)
IN 1
Y
AUTO
REC
DIGITAL OUT
OPTICAL IN 3 P
B
OUT P
R
To VIDEO/AUDIO
output jacks
Antenna cable
To Antenna/cable TV
wall outlet
19
To VIDEO/AUDIO
IN 2 jacks
Video/Audio
cable
(Commercially
available)
5
To VIDEO/AUDIO
output jacks
Coaxial cable
(Supplied)
2
To IN FROM
ANTENNA
IN FROM
ANTENNA
VHF/UHF/CATV
OUT TO TV
1
03.1.14, 11:18 AM
1
Connect the TV antenna
cable to the IN FROM
ANTENNA jack on the rear
of this recorder.
2
Connect the OUT TO TV
jack on the rear of this
recorder to the antenna
input jack on your VCR
using a coaxial cable.
NOTE
• If you connect this recorder directly
to your TV, skip the next step.
• The input signal to IN FROM
ANTENNA jack is passed through to
the OUT TO TV jack.
3
Connect the antenna
output jack on your VCR to
antenna input jack on your
TV using a coaxial cable.
4
Connect the VIDEO/AUDIO
output jacks on this recorder
to the VIDEO/AUDIO input
jacks on your TV using a
Video/Audio cable.
Be sure that the colors of the
jacks and plugs match up when
connecting the cable.
NOTE
• To connect using S-Video or
component cables, see "Using
other types of video output" on the
next page.
5
Connect the VIDEO/AUDIO
output jacks on your VCR
to the VIDEO/AUDIO input
jacks on your TV using a
Video/Audio cable.
Important!
• When using this connection, set
"PROGRESSIVE" in "PLAYBACK
SETUP" to "OFF". (When the
setting is "ON", the disc playback
picture cannot be viewed.)
After the Connection
Plug in the power cords of the TV and
VCR. Then go to "EZ Set Up" (see
page 23).
19