Sharp DV-RW2U Operation Manual page 55

TIMER
DISC OPEN/
POWER
ON/OFF
TIMER CLOSE
CH
ANGLE AUDIO
SETUP/
DNR ZOOM INPUT
FUNCTION
TITLE MENU
SET/
RETURN ENTER
VCR PLUS +
TIMER PROG.
REC MODE
AM/PM ERASE PROGRAM
100
REV FWD
PLAY
REC
STILL/PAUSE
STOP
SKIP F.ADV
SEARCH SKIP SLOW
ON
ORIGINAL/
DISPLAY SCREEN EDIT
PLAY LIST
POWER INPUT VOL
CH
TV CONTROL
DV_RW2U#p54-61.p65
9
Press SET/ENTER.
• To program additional timer settings,
press SET/ENTER and repeat steps
3–9.
10
Press RETURN to finish
settings.
11
Press TIMER ON/OFF to enter
the timer standby mode.
• The power turns off, and the recorder
enters the timer standby mode (the
TIMER indicator on the recorder lights
up).
• During playback, the power does not
turn off, but the timer recording will be
set.
NOTE
• If the power is interrupted for more than
1 hour (power failure, etc.) during timer
recording, the Auto Clock Setting will reset
the time after the power is returned (the
timer indicator on the Front Panel Display
will blink.) but the timer settings will be
canceled.
• Number buttons can be used instead of
' ' / " ' ' " " to set the data. " "
'
• To stop timer recording, press ËSTOP.
• If a button is not pressed within 3 minutes
during the setting procedure, the screen
will return to the normal screen.
• There are two timer setting screens (1/2, 2/2).
• The following causes are possible when the
TIMER indicator is blinking or "ERROR" is
displayed when TIMER ON/OFF has been
pressed.
• A recording has been programmed
having a recording time of 1 minute
• Inadequate available disc space
• The disc is protected
• No disc is loaded in the recorder
• Disc identification is not finished
Repeat the procedure after checking the
recording time and disc.
55
Timer Recording
03.1.14, 9:33 AM
55