Table of Contents
Advertisement
INSTALLATION &
OPERATION MANUAL
FOOD HOLDING & TRANSPORTATION CABINETS
AND BANQUET CARTS
MODELS:
1220-3-BC
1220-7
1220-8-BC
1220-15-BC
1220-20-BC
1826-5-BC-IS
1826-7-BC-IS
1826-7-DBL-IS
1826-7-SCH
1826-13-BC-IS
1826-15-BC-IS
1826-15-SCH
2-90
2-96
2-150
580
For additional information on WITTCO or to locate an authorized parts
and service provider in your area, visit our website at
www.wittco.com
WITTCO FOOD SERVICE EQUIPMENT
7737 NORTH 81 STREET
DIVISION OF ITW FOOD EQUIPMENT GROUP, LLC
MILWAUKEE, WI 53223
www.wittco.com
F-41013 (03-11)
© 2011 Wittco Foodservice Equipment
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Wittco 1220-3-BC
Summary of Contents for Wittco 1220-3-BC
- Page 1 1826-15-BC-IS 1826-15-SCH 2-90 2-96 2-150 For additional information on WITTCO or to locate an authorized parts and service provider in your area, visit our website at www.wittco.com WITTCO FOOD SERVICE EQUIPMENT 7737 NORTH 81 STREET DIVISION OF ITW FOOD EQUIPMENT GROUP, LLC MILWAUKEE, WI 53223 www.wittco.com...
-
Page 2: Important For Your Safety
H & T CABINETS F-41013 (03-11) IMPORTANT FOR YOUR SAFETY THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL ELECTRICAL EQUIPMENT, WHO SHOULD PERFORM THE INITIAL FIELD START- UP AND ADJUSTMENTS OF THE EQUIPMENT COVERED BY THIS MANUAL. FOR YOUR SAFETY DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS OR LIQUIDS IN THE VICINITYOF THIS OR ANY OTHER APPLIANCE. -
Page 3: Table Of Contents
H & T CABINETS F-41013 (03-11) TABLE OF CONTENTS IMPORTANT FOR YOUR SAFETY ........1 GENERAL . -
Page 4: General
F-41013 (03-11) GENERAL If the cabinet is found to be damaged, INTRODUCTION save the packaging material and contact the carrier within 15 days of Wittco Holding & Transport Cabinets delivery. and Banquet Carts are produced with quality workmanship material. Carefully unpack and place in a work... -
Page 5: Electrical Requirements
H & T CABINETS F-41013 (03-11) CLEANING: ELECTRICAL REQUIREMENTS The cabinet should be thoroughly cleaned prior to putting into service. ELECTRICAL CODES & STANDARDS: cabinet must installed Use a mild soap and water solution to accordance with: clean the interior of the unit. Never use harsh chemicals or abrasive pads to In the United States of America: clean the unit. -
Page 6: Operation
H & T CABINETS F-41013 (03-11) grounding type, contact electrician. Do not remove the grounding prong from this plug. Verify that power source matches the Serial Data Plate located on the lower back corner of the cabinet and the plug configuration before connection made. -
Page 7: Operating Instructions
H & T CABINETS F-41013 (03-11) Approximate OPERATING INSTRUCTIONS Thermostat Temperature Setting 100⁰F (37⁰C) The Cabinet and its parts 110⁰F (43⁰C) are hot. Be very careful when operating, 120⁰F (49⁰C) cleaning, or servicing the cabinet. 130⁰F (54⁰C) Once the cabinet has been connected to 140⁰F (60⁰C) the appropriate power source, the 150⁰F (66⁰C) -
Page 8: Stainless Steel Care
H & T CABINETS F-41013 (03-11) PRESERVING & RESTORING: STAINLESS STEEL CARE Special stainless steel polishing cleaners can preserve and restore the CLEANING: protective film. Stainless Steel contains 70 – 80% iron, which will rust if not properly maintained. Preserve the life of stainless steel with a Stainless Steel also contains 12 –... -
Page 9: Lockout / Tagout Procedure
H & T CABINETS F-41013 (03-11) LOCKOUT / TAGOUT PROCEDURE Always perform the LOCKOUT / TAGOUT Procedure before removing any sheet metal panels or attempting to service this equipment. The Lockout / Tagout Procedure is used to protect personnel working on an electrical appliance. -
Page 10: Troubleshooting
Contact Authorized Service Defective fan Provider. SERVICE & PARTS INFORMATION To obtain Service and Parts information concerning this model, contact Wittco Service Department at the address listed on the front cover of this manual or refer to our website: www.wittco.com for a complete listing of Authorized Service and Parts depots. -
Page 11: Specifications
(1676) (584) (781) (144 kg) 1200 62.25" 24.75" 38" 370# (1582) (629) (966) (169 kg) 2000 16.7 23.5" 18" 23.75" 1220-3-BC (597) (457) (604) (36.6 kg) 36.75" 21" 26.75" 140# 1220-7-BC (934) (534) (680) (64 kg) 31.5" 18.25" 25" 1220-8-BC... -
Page 12: Wiring Diagrams
H & T CABINETS F-41013 (03-11) WIRING DIAGRAMS Models Manufactured before 2010: 2-90, 2-96, 2-150, 1826-5-BC-IS, 1826-7-BC-IS, 1826-13-BC-IS, 1826-15-BC-IS, 1826-7-SCH, 1826-15-SCH, 1220-15 BC, 1220-20-BC... - Page 13 H & T CABINETS F-41013 (03-11) Model Manufactured before 2010 1826-7-DBL-IS...
- Page 14 H & T CABINETS F-41013 (03-11) Models Manufactured before 2010 1220-3-BC, 1220-7, 1220-8-BC...
- Page 15 H & T CABINETS F-41013 (03-11) Model Manufactured 01/01/2010 THROUGH 01/20/2011 1826-7-DBL-IS...
- Page 16 H & T CABINETS F-41013 (03-11) Models Manufactured after 2010 1826-5-BC-IS, 1826-7-BC-IS, 1826-13-BC-IS, 1826-15-BC-IS 1826-7-SCH, 1826-15-SCH 1220-7-BC, 1220-15-BC Model Manufactured after 01/20/2011 1826-7-DBL-IS...
Need help?
Do you have a question about the 1220-3-BC and is the answer not in the manual?
Questions and answers