Life Span E5i Owner's Manual page 21

G. Remove the Bolt from the
lower end of the right mid
arm and right pedal arm. Re-
move the Right Mid Arm from
the Main Base(1). Reinstall the
removed bolt into the Right
Pedal Arm being sure the
spacer is still in place.
H. Repeat step G for the Left Mid
Arm and Pedal Arm.
I. Cut the corners
of the bottom
box and remove
all packaging.
J. Place Rail Base(2)
in position with
mounting holes
in Main Base(1).
Step 2: Hardware Loss Prevention Sheet
A. The Main Base (1) has the Hardware Loss Prevention Sheet draped around
the Console Mast Support. The purpose of this paper is to act as a shield
to prevent bolts, washers and screws from falling into the Main Base
during assembly. Do not remove until assembly is complete. The paper
tears off easily when done and can be thrown away.
2
I
Hardware Loss
Prevention Sheet
Do Not Remove Until
Assembly is Complete
Assembling Your Elliptical
H
G
J
Note: The bolts are
being reinstalled so
they are not lost for
future assembly steps.
Make sure the sleeve
in the center of the
bearing is still in place
prior to reinstalling
the bolt.
1
25