Using The Magic Bullet - Magic Bullet MBR-1701 User Manual And Recipes

USING THE
MAGIC BULLET
Using the Magic Bullet is as
easy as 1, 2, 3:
1
Load the ingredients into the
Tall Cup or Party Mug.
2
Twist on the Cross Blade or
Flat Blade until the blade and
cup have a tight seal.
3
Line up the tabs on the cup
and with the tabs on the Power
Base. Press the cup down onto
the base to turn on the machine.
HERE'S HOW IT WORKS:
The Magic Bullet will blend for
as long as you press the cup
down onto the Power Base. To
stop blending, simply release
pressure on the cup.
14
CAUTION:
Before using the blade, check
the gasket to make sure it is not
damaged and it is completely
seated in the blade unit before
each use.
Never put your hands or utensils
near the moving blades and never
use your hands or utensils to press
the activator buttons down while the
Power Base is plugged in.
IF THE BLADE STOPS SPINNING
WHILE IN LOCK ON MODE,
IMMEDIATELY UNPLUG THE
MAGIC BULLET. Hard ingredients
like carrots or celery can get
stuck in the blade and stop it from
turning. If this happens, UNPLUG
THE MAGIC BULLET RIGHT AWAY.
Remove the blade/cup assembly
from the Power Base, and give
"LOCK ON" MODE:
For hands-free operation, press
down and gently turn the cup
clockwise until the tabs lock
under the lip of the Power
Base. Once you are in Lock
On Mode, the motor will run
continually. To turn it off, simply
twist the cup back counter-
clockwise and release the cup.
ingredients a good shake to
unblock the blade. If the blade still
remains obstructed, twist the blade
attachment off of the cup and
carefully spin the metal blades by
hand (they are sharp) to release the
blockage. Reattach the blade to the
cup, plug in the Magic Bullet and
try again. It should spin normally.
NEVER RUN THE MAGIC BULLET
FOR MORE THAN ONE MINUTE
AT A TIME, AS IT CAN CAUSE
PERMANENT DAMAGE TO THE
MOTOR. If the motor stops working,
unplug the Power Base and let it cool
for a few hours before attempting
to use it again. Your Magic Bullet
has an internal thermal breaker that
shuts the unit off when it overheats.
Letting the thermal breaker cool down
should allow it to reset.
15