Troubleshooting; Fault Indication - Insignia NS-BC48SS7 User Manual

Troubleshooting

Fault indication

If a fault is detected, the display shows one of the following codes:
Fault code
Description Temperature sensor fault
PROBLEM
The beer and beverage
cooler does not operate
The cooler door does
not close completely
The cooler is not cold
enough
E1
POSSIBLE CAUSE
The beer and beverage cooler
is unplugged.
The fuse on the circuit is blown
or the circuit breaker is
tripped.
Power failure.
The shelf is out of position.
The door gaskets are dirty.
The cooler is not level.
The door has been opened too
often or was not closed
properly.
You have just added a large
amount of warm beverage to
the cooler.
The temperature control is set
too warm.
www.insigniaproducts.com
48-, 78-, 115-Can Beer and Beverage Cooler
Caution
Do not try to repair your beer and beverage cooler yourself.
Doing so invalidates the warranty.
Defroster sensor fault
Note
When the above faults are displayed, do not attempt to repair
the cooler by yourself. Please contact customer service for help.
POSSIBLE SOLUTION
Make sure that the beer and beverage cooler is plugged in and
that the plug is pushed completely into the outlet.
Check the house fuse/circuit breaker box and replace the fuse or
reset the circuit breaker.
If a power failure occurs, the beer and beverage cooler turns off.
Wait until the power is restored, then turn it on again.
Adjust the shelf properly.
Clean the door gaskets.
Level the cooler with the leveling feet.
Make sure that the door is closed properly.
Allow time for the new beverage to cool, then check again.
Set the control to a colder setting.
E2
15