Fips - Uniden Polaris Owner's Manual

UT888ZL (POLARIS)-0708
To set USER MMSI code
1. Press Menu key
2. Rotate the PUSH – SELECT knob to
select SETUP.
3. Press PUSH – SELECT at SETUP,
then the SETUP menu appears.
4. Rotate the PUSH – SELECT knob to
select USER MMSI, and Press
PUSH – SELECT, and then following
screen appears.
5. You can enter the USER MMSI code.
Rotate the Channel/Select knob
clockwise to increase the number,
counterclockwise to decrease. The
number will be decided when PUSH
– SELECT is pressed, and the
blinking digit moves to the next digit.
6. After the final digit is selected, the
confirmation screen appears, and
you can select either answer by
rotating PUSH – SELECT knob, and
press PUSH – SELECT.
Note: You can program only twice, and
you need to send Polaris back to
Uniden to be programmed.
7/8/02 8:13 PM Page 29
29

FIPS

&&
USER MMSI
GROUP MMSI
U.I.C
DIRECTORY
AUTO.CH.SW
SET MMSI
&&
000000000