Battery Installation - Scout; Inserting The Holder Into The Scout - Decatur Electronics GHD User Manual

GHD & SCOUT
TM

3.4 Battery Installation - SCOUT

Insert the batteries into the battery holder following the polarity
guide that is on the inside of the battery holder (Figure 3.4a.) Once
properly loaded the battery holder will look like the example in
Figure 3.4b

3.5 Inserting the Holder into the SCOUT

The battery holder is designed so that it can only make contact with
the power connections inside the gun if the holder is slid into the
gun in the correct way. If you look closely at the holder you will see
that there is a positive and negative terminal on it. These need to be
inserted into the gun with the terminals located at the top as shown in
the picture below.
8
TM
Figure 3.4a
Notice that the negative side of each battery goes to
the spring contacts of the holder.
Figure 3.4b
Figure 3.5
USER'S MANUAL