Connecting The Ethernet Network Card To Other Inverters; Connecting A 3 Rd Party Monitoring System To The Ethernet Network Card; Preparing The Ethernet Network Card - YASKAWA PVI 60TL Installation And Operation Manual

PVI 50/60 TL Installation and Operation Manual (Rev C)

2.4.3 Connecting the Ethernet Network Card to other inverters.

1. The connector in the upper left corner of the Ethernet Network Card allows for a
connection of the inverter daisy chain on the Communication Card.
2. Since the Ethernet Network Card acts as the end of the inverter daisy chain, termination
must be turned on. Set the termination resistor S4 to the ON position on the Ethernet
Network Card. Set the termination resistor S1 to the ON position on the Communication
Card in the inverter at the opposite end of the inverter daisy chain.
rd
2.4.4 Connecting a 3 Party Monitoring System to the Ethernet
Network Card
1. From the DAS, connect the RS485 to the 3 pin connector on the Ethernet Network Card.
Do not connect to the communication card.
2. Tighten all wires securely.
3. If the Ethernet Network Card is the last device in the DAS chain, set the termination
resistor S3 ON.
Connect
external RS485
(DAS) here
Figure 2-48 Ethernet Network wiring to DAS

2.4.5 Preparing the Ethernet Network Card

The Ethernet Network Card comes preset with DHCP settings. It will automatically
pull a dynamic IP address and connect to the Internet. If you need to assign a static
IP address please refer to the documentation provided with the board or go to
Solectria.com and search for "Ethernet Network Card".
DOCR-070645-E Page 54 of 102