Table of Contents
Advertisement
Being the exterior unit in the dry or fan modes, if the KLIC-DI that controls the
slave of mode unit sends the heat mode then the slave of mode unit will switch
to cool mode.
Being the exterior unit in the heat mode, if the KLIC-DI that controls the slave of
mode unit sends the cool mode then the slave of mode unit will switch to the
fan mode.
Being the exterior unit in the dry or fan modes, if the KLIC-DI that controls the
slave of mode unit sends the cool mode, then the slave of mode unit will switch
to the heat mode.
Note: when KLIC-DI is configured as the master of mode, the wired remote controls of
the A/C unit cannot be used to set additional masters of mode.
3.2.7 SWING
Through this parameter, it is possible to select whether to permit controlling the swing
function (i.e., the slats that address the air flow) of the A/C machine. The availability of
such function in the particular A/C unit being controlled needs to be confirmed in
advance.
Important: in case of not being available swing control in the machine, enabling this
parameter may cause an abnormal behaviour of the air machine.
http://www.zennio.com
Figure 14. Swing
Technical Support:
KLIC-DI VRV
http://support.zennio.com
21
Advertisement
Table of Contents
