Table of Contents
Advertisement
3.2.1 SCENES
After enabling this function, the left menu will show a new tab named Scenes, from
where it will be possible to set up different scenes (up to 4), consisting each of them in
a set of orders to be sent to the A/C unit upon the reception, through the KNX bus and
by means of the object "Scenes: Receive", of the corresponding scene value
(decreased by 1, according to the KNX standard).
For every enabled scene, the particular parameters that may be configured are the
following:
Scene number. Sets the scene number (1-64) on whose reception (through
the Scenes object, decreased by one) the corresponding configured orders
will be sent to the A/C machine. The available orders are:
➢ On/Off. Brings the possibility of setting the A/C machine state: No change,
on or off.
➢ Temperature. No change, or a New temperature setpoint (from 16ºC to
32ºC).
➢ Mode. No change, Auto, Heat, Dry, Fan or Cool.
➢ Fan. No change, minimum or maximum.
➢ Swing. No change, swing (in motion) or in any of the five fixed positions
available.
An example of scene configuration is shown in Figure 8.
http://www.zennio.com
Figure 7. Scene configuration
Technical Support:
KLIC-DI VRV
http://support.zennio.com
14
Advertisement
Table of Contents
