Type Of Control - Zennio KLIC-DI User Manual

Swing: Last, In motion or in any of the 5 fixed positions available.
Moreover, the status objects can be sent to the bus when applying the initial settings:
Send initial configuration to bus?: If enabled ("Yes"), a new field will
appear next, "Delay", where to configure the time, in seconds, KLIC-DI will
delay the sending of the status objects to the KNX bus.
Note: if the parameterised delay is too short, the status objects sent to the
bus may not show the selected custom configuration. In such case, an
additional transmission of the objects will take place once the custom
configuration becomes effective and has been confirmed by the machine.

3.2.6 TYPE OF CONTROL

The control type of the KLIC-DI interface is also parameterised from the General
window. This can be Master Remote Control or Slave Remote Control, depending
on whether or not there is an additional wired remote control in the A/C system bus.
Please refer to the "Control type" subsection under section 2.2.
On the other hand, when the control type is set to Master Remote Control, an
additional drop-down list ("Master/Slave of Mode") is displayed. Note that it only
makes sense to configure the device as a Master of Mode or as a Slave of Mode once
it has been set as a Master Remote Control.
The concept of the Master of Mode derives from the possibility of having multiple
indoor A/C units within the same facility (e.g., one per floor), all of them connected to a
single outdoor unit, which typically means that (unless a BS box has been installed)
only one main mode can be active at a time, and therefore only one internal unit
may work as a master of mode, being the only one capable of switching the active
mode. The remaining indoor units (and their respective master or slave controls) will
act as slaves of mode, thus will only have certain modes available, depending on the
currently active main mode.
http://www.zennio.com Technical Support: http://support.zennio.com
KLIC-DI VRV
19