Table of Contents
Advertisement
As shown in Figure 6, the configuration window is initially divided into three main tabs:
General: allows individually enabling the control over the advanced
functionalities of the A/C unit.
Mode: allows configuring different attributes related to the selection of the
mode of operation of the A/C unit.
Fan: allows configuring features related to the fan speed of the A/C unit.
The next sections cover all of the above in detail.
3.2 GENERAL
From the General parameter window it is possible to select the advanced functionalities
to be controlled from KLIC-DI (scenes, setpoint restriction, auto OFF, error handling,
initial configuration...). All of them, which will be explained in the next section, are
disabled by default.
From the General window it is also possible to configure the desired control type for
KLIC-DI (master control or slave control) and the indoor temperature sending time
(30 – 255, in seconds), which allows carrying out a periodical sending to the KNX bus
(through the "Internal Temperature (Status)" object) of the internal temperature
measured by the machine, even if the value does not change.
http://www.zennio.com
Figure 6. Default general configuration
Technical Support:
http://support.zennio.com
KLIC-DI VRV
13
Advertisement
Table of Contents
