Print Settings; Default Settings - Sharp AR-M257 Key Operator's Manual

PROGRAMS FOR PRINT MODE
This chapter explains key operator programs that are used for the printer function. These programs can only be
configured on models that have the printer function.

PRINT SETTINGS

KEY OPERATOR PROGRAMS
PRINT SETTINGS

DEFAULT SETTINGS

NETWORK SETTINGS
DEFAULT SETTINGS
These programs allow you to change certain default
settings for the printer function.
The "DEFAULT SETTINGS" consist of the following
programs:
● PROHIBIT NOTICE PAGE PRINTING
● PRINT DENSITY LEVEL
● PROHIBIT TEST PAGE PRINTING
● ROTATED PRINT
● FORCED OUTPUT OF PRINT
● EXCLUDE BYPASS-TRAY FROM ATS
● DISABLE DEFAULT SETTING CHANGES
PROHIBIT NOTICE PAGE PRINTING
This program is used to prohibit the printing of notice
pages. For an explanation of notice pages, see "If a
Notice Page is printed" in the online manual for printer.
This program is initially disabled (factory default
setting).
PRINT DENSITY LEVEL
The print density can be set to one of five different
levels. [1] is the lightest level and [5] is the darkest
level.
The factory default setting is "3".
PROHIBIT TEST PAGE PRINTING
(When the PRINTER EXPANSION KIT is installed)
This program is used to prohibit the printing of test
pages.
When the program is enabled, a test page cannot be
printed from the user settings. (See the operation
manual for copier)
This program is initially disabled (factory default
setting).
ROTATED PRINT
This program is used to enable or disable rotation of
the print image when an A4R, B5R, or 8-1/2 x 11R
(Letter R) document is being printed but there is no
paper loaded in that orientation.
This program is initially enabled (factory default
setting).
16
OK
INTERFACE SETTINGS
INITIALIZE AND/OR STORE
SETTINGS
FORCED OUTPUT OF PRINT
This program is used to enable or disable automatic
printing on a different size of paper when no paper
trays have the selected size of paper.
This program is initially disabled (factory default
setting).
EXCLUDE BYPASS-TRAY FROM ATS
This program is used to exclude paper in the bypass
tray when automatic paper selection is used.
This program is initially enabled (factory default
setting).
DISABLE DEFAULT SETTING
CHANGES
(When the PRINTER EXPANSION KIT is installed)
This program is used to prevent the configuration
setting defaults from being changed.
This program is initially disabled (factory default
setting).