Sharp AF-100DX Installation And Operation Manual page 7

6
Insert the closure assemblies on both
sides into the rails of the jamb.
Closure assembly
(Left)
Sill
7
(1) Secure the cabinet to the window
stool with 3 screws (L=1", 25.4 mm),
working from the inside of the cabinet.
(2)
Secure the top angle and the closure
assemblies to the window sash with 3
screws (L=1", 25.4 mm).
(3) Secure the closure assemblies to the
sill with 2 screws (L=1", 25.4 mm).
8
(1)
Slide the chassis back into the cabinet.
(2) Replace the 4 screws removed in
step 3 to the top and side of the cabinet .
9
(1)
Replace the front panel. Slip the ex-
haust lever through the opening
between the horizontal louver and the
front panel then, hook the cabinet top.
CAUTION:
Take care not to damage the exhaust
lever with the front panel.
(2)
Screw the front cabinet on at the bottom
corners with 2 screws removed in step 2.
10
Cut the window sash foam seal to the
proper length and seal the opening be-
tween the top of the inside window sash
and the outside window sash.
Jamb
(Left)
1/2 inch (13mm)
Stool
INSTALLATION INSTRUCTIONS
Closure assembly
(Left)
Indoor
side
Window sash foam seal
Top angle
Horizontal
Louver
Front
Exhaust Lever
Panel
7