Test Run - Daikin FTQ18TAVJUA Installation Manual

14(24)-4-XX
XX 01
UV lamp + humidifier Refer to
Fan speed controller
Economizer setting
for Mech standby 10
duration (min)
XX 06
UV lamp + humidifier
High
Fan speed
Economizer setting
30
for Mech standby
duration (min)
XX 11
UV lamp + humidifier Refer to
Fan speed controller
Economizer setting
60
for Mech standby
duration (min)
(*) Factory Set
UV Lamp + Humidifier + Economizer
Optional Kit Setting
Mode No. 14(24)
First Code No. 4
Second Code No. XX
10.1 SETTING FOR SEPARATELY SOLD
ACCESSORIES
• See the instruction manuals included with optional
accessories for the necessary settings.
When using a wireless remote controller
• A wireless remote controller address needs to be set when
using a wireless remote controller. See the installation manual
included with the wireless remote controller for details on
how to make the settings.

11. TEST RUN

• Perform a test run according to the outdoor unit's installation
manual.
• The operation lamp of the remote controller will flash when a
malfunction occurs. Check the malfunction code on the liquid
crystal display to identify the point of trouble. An explanation
of malfunction codes and the corresponding trouble is
provided in "CAUTION FOR SERVICING" of the outdoor unit.
If the display shows any of the following, there is a possibility
that the wiring was done incorrectly or that the power is not
on, so check again.
20
02 03 04
Refer to
High High
controller
10 20 20
07 08 09
Refer to Refer to
High
controller controll
40 40 50
12 13 14 (*)
Refer to
High High
controller
Free Free
60 cooling cooling
only only
Remote control display
CENTRAL
"
05
CONTROL
Refer to
"U3" display
controll
30
"U4" display
"UH" display
10
High
"UF" display
50
No display
• Always stop the test run using the remote controller to stop
operation.
Content
There is a short circuit at the FORCED
"
display
OFF terminals (T 1 T 2
The test-run has not been performed.
The power on the indoor unit is off.
The outdoor unit has not been wired for
power supply.
Wiring is incorrect for the transmission
wiring and/or FORCED OFF wiring.
The transmission wiring is cut.
Reversed transmission wiring
The power on the indoor unit is off.
The indoor unit has not been wired for
power supply.
Wiring is incorrect for the remote
controller wiring, transmission wiring
and/or FORCED OFF wiring.
The transmission wiring is cut.
).
English