Network; Wan - TP-Link TL-WR850N User Manual

Chapter 4
• Wireless Radio
• Name (SSID)
• Mode - The current wireless working mode in use.
• Channel Width
• Channel - The current wireless channel in use.
• MAC Address
• WDS Status
•

WAN

- This field displays the current settings of the WAN, and you can configure them
on the

Network

> WAN
• MAC Address
• IP Address
or 0.0.0.0 if the IP Address is assigned dynamically and there is no Internet
connection.
• Subnet Mask
• Default Gateway
Dynamic IP as the Internet connection type, click
obtain new IP parameters dynamically from the ISP or release them.
• DNS Server
• System Up Time - The length of the time since the router was last powered on or
reset.
Click Refresh to get the latest status and settings of the router.
4 2 Network
4 2 1 WAN
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the
router.
2. Go to Network > WAN.
3. Configure the IP parameters of the LAN and click Save.
Dynamic IP
If your ISP provides the DHCP service, please select
automatically get IP parameters from your ISP.
Click Renew to renew the IP parameters from your ISP.
4. Click Release to release the IP parameters.Click
by-step instructions to connect your router to the internet.
- Indicates whether the wireless feature is enabled or not.
- The SSID of the router.
- The current wireless channel width in use.
- The physical address of the router.
- The status of WDS connection.
page.
- The physical address of the WAN port.
- The current WAN (Internet) IP Address. This field will be blank
- The subnet mask associated with the WAN IP Address.
- The Gateway currently used is shown here. When you use
- The IP addresses of DNS (Domain Name System) server.
Configure the Router
Renew or Release
Dynamic IP, and the router will
Next to start. Then follow the step-
here to
14