Messages - Sony MHC-EC599 Operating Instructions Manual

2
Press "/1 to turn off the system.
3
After "STANDBY" stops flashing,
press DISPLAY to display the
clock.
4
While holding down x on the unit,
press "/1 on the unit.
"CD/USB PWR OFF" appears in the
display panel.
The disc access time is increased.
To turn on the CD player/USB device
power, repeat the procedure until
"CD/USB PWR ON" appears.
Note
When the CD player/USB device power is
turned off in TUNER function, power is not
supplied to the USB device, and the device is
therefore not recognized and not charged by the
system, even if connected.
To reset the system
If the system still does not operate
properly, reset the system to factory
default settings.
Use the buttons on the unit to perform this
operation.
1
Unplug and plug the power cord
back in.
2
Press "/1 to turn on the system.
3
Hold down x, ENTER and "/1 at
the same time.
"RESET" appears in the display panel.
All user-configured settings, such as
preset radio stations, timer, and the
clock are reset to factory default
setting.

Messages

Disc/Timer
FULL
You tried to program more than 25 steps.
NO DISC
There is no disc on the disc compartment
or you have loaded a disc that cannot be
played back on this system.
NO STEP
All of the programmed steps have been
erased.
NOT USED
You have pressed a button those operation
is not allowed or invalid at this time.
OVER
You have reached the end of the disc
while pressing M during playback or
pause.
PUSH SELECT
You tried to set the clock or timer during
timer operation.
PUSH STOP
You tried to perform an operation that can
be performed only when the playback is
stopped.
READING
The system is reading information of the
disc. Some buttons are not available.
SET CLOCK
You pressed CLOCK/TIMER SELECT
before the clock is set.
SET TIMER
You pressed CLOCK/TIMER SELECT
before the Play Timer is set.
TIME NG
The Play Timer start time and stop time is
the same.
l
Continued
23 GB