Previewing The Alarm And Turning The Alarm On/O - iHome iBT233V2 Instruction Manual

Setting and Using the Alarms
1. Press and hold the Alarm Button for 2 seconds until the alarm time display, alarm button
and alarm icon flash. A beep sounds.
2. Press the or
setting). Make sure you set the correct AM/PM alarm time. The PM indicator appears to the
left of the display; there is no AM indicator.
3. Press the Alarm Button to confirm the alarm time setting. The alarm schedule will flash.
4. Press the or
days) or "2 d" (weekends).
5. Press the Alarm Button to confirm the alarm schedule setting. The wake-to source will flash.
6. Press the or
or selected tone.
Wake to Bluetooth: You will wake to the currently linked Bluetooth device. If no device is
detected at wake time, the alarm will default to tone one ("t1").
Wake to Radio: Press the Alarm Button to confirm. Press the Presets Button to select an FM
preset to wake to, or press the
Presets, see Setting and Using FM Presets on page 10.)
Wake to Tones: You will wake to the selected tone. Press the Alarm Button to confirm, then
press the or
7. Press the Alarm Button to confirm the wake to source. The alarm volume will flash.
8. Press the or
9. Press the Alarm Button to complete alarm setting and exit alarm setting mode. 2 beeps will
confirm alarm setting is complete. The alarm icon will remain on the display, indicating the
alarm is armed.
8. To turn o a sounding alarm and reset it to come on the next day at the same time, press
Power Button or the associated alarm button (
the

Previewing the Alarm and Turning the Alarm On/O

Press and release the desired Alarm Button as needed to toggle the alarm ON (indicated by the
alarm icon and lit alarm button) or OFF (no alarm icon/alarm button is not lit).
Buttons to adjust the alarm time to the desired time (hold for rapid
Buttons to cycle to the desired schedule: "7 d" (every day), "5 d" (week
Buttons to select the desired wake to alarm source: Bluetooth, FM radio
or
Buttons to preview and select a desired tone (t1 -t4).
Buttons to select the desired alarm volume.
Using the
(Continued)
Buttons to tune in a desired wake to station. (To set
8
iBT233V2
or ) to reset alarm.