MYERS SP75 Series Installation, Operation & Parts Manual

1101 Myers Parkway
Ashland, OH 44805
Phone: 1-419-289-6898
Fax: 1-419-289-6658
Web Site: http://www.myerspump.com
Submersible Sump Pumps
INSTALLATION, OPERATION, & PARTS MANUAL

SAFETY INFORMATION

Carefully read and follow all safety instructions in this
manual or on pump.
This is the safety alert symbol. When you see this
symbol on your pump or in this manual, look for one of the
following signal words and be alert to the potential for
personal injury!
warns about hazards that will cause serious
personal injury, death or major property damage if ignored.
warns about hazards that can cause serious
personal injury, death or major property damage if ignored.
warns about hazards that will or can cause
minor personal injury or property damage if ignored.
The word NOTICE indicates special instructions which are
important but not related to hazards.
Electrically powered sump pumps normally give many years
of trouble-free service when correctly installed, maintained,
and used. However, unusual circumstances (interruption of
power to the pump, dirt/debris in the sump, flooding that
exceeds the pump's capacity, electrical or mechanical failure
in the pump, etc.) may prevent your pump from functioning
normally. To prevent possible water damage due to flooding,
consult your dealer about installing a secondary sump
pump, a DC backup sump pump, and/or a high water alarm.
See the "Troubleshooting Chart" in this manual for informa-
tion about common sump pump problems and remedies.
MOTOR, SWITCH, & CORD SPECIFICATIONS
Model Motor
Number HP
SP75P1 3/4
SP75PC1 3/4
SP75MC1 3/4
© 2008
1. Know the pump application, limitations, and potential
2. Disconnect power before servicing.
3. Release all pressure within system before servicing any
4. Drain all water from system before servicing.
5. Secure discharge line before starting pump. An unse-
6. Check hoses for weak or worn condition before each
7. Periodically inspect sump, pump and system compo-
8. Provide means of pressure relief for pumps whose dis-
9. Personal Safety:
10. When wiring an electrically driven pump, follow all elec-
11. This equipment is only for use on 115 volt and is
Individual
Max. Branch Circuit
Load Amps Required (Amps)
7.5 15
7.5 15
7.5 15
hazards.
component.
cured discharge line will whip, possibly causing personal
injury and/or property damage.
use, making certain that all connections are secure.
nents. Keep free of debris and foreign objects. Perform
routine maintenance as required.
charge line can be shut-off or obstructed.
a. Wear safety glasses at all times when working with
pumps.
b. Keep work area clean, uncluttered and properly light-
ed – replace all unused tools and equipment.
c. Keep visitors at a safe distance from work area.
d. Make workshop child-proof – with padlocks, master
switches, and by removing starter keys.
trical and safety codes that apply.
equipped with an approved 3-conductor cord and
3-prong, grounding-type plug.
Cord
Length
10' 11" (279)
20' 11" (279)
20'
SP75 Series
Switch Setting
in inches (mm)
On Off
3-1/2" (89)
3-1/2" (89)
– –
MY502 (Rev. 2/20/08)