MYERS  S33 Instruction And Service Manual

MYERS S33 Instruction And Service Manual

Sump pump

Advertisement

S33 Sump Pump
INSTRUCTIONS AND SERVICE MANUAL
VERTICAL
FLOAT SWITCH
S33V1 & S33V1C
AUTOMATIC
S33P1 & S33PC-1
(CONTROL WITH SERIES PLUG)
NOT SHOWN
AUTOMATIC
S33A1 & S33A1C
R
23833A587
Bag #18812A108

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MYERS S33 and is the answer not in the manual?

Questions and answers

Ron Selkers
July 10, 2025

What is the oil capacity of the Meyers Septic pump MD# ME 33S - 11

Summary of Contents for MYERS MYERS S33

  • Page 1 S33 Sump Pump INSTRUCTIONS AND SERVICE MANUAL VERTICAL FLOAT SWITCH S33V1 & S33V1C AUTOMATIC S33P1 & S33PC-1 (CONTROL WITH SERIES PLUG) NOT SHOWN AUTOMATIC S33A1 & S33A1C 23833A587 Bag #18812A108...
  • Page 2 WARNING risk of electric shock. This pump is supplied with a grounding conductor and grounding-type attachment plug. To reduce the risk of electric shock, be certain that it is connected only to a properly grounded, grounding-type receptacle. Pumps can be installed with ABS, PVC or polyethylene plastic pipe, or galvanized or copper pipe. Proper adapters are required to connect plastic pipe to pump.
  • Page 3: Performance Table

    IMPORTANT INSTRUCTIONS BEFORE INSTALLATION Failure to follow these instructions may cause serious bodily injury and/or property damage. Warranty void if product modified, drilled, painted, or altered in any way; if used to pump hot water, or to pump liquids other than water (such as but not limited to chemicals, fertilizers, flammable liquids, herbicides, mud, tar, cement, wood chips);...
  • Page 4 COMPLETE SUBMERSIBLE SUMP PUMP INSTALLATION Refer to the installation illustrations below and on the following page for the following instructions. Be certain sump basin is clean and all power to pump is shut off. If pump fails to operate properly after installation, refer to the troubleshooting checklist on page 6 or contact your STEP Thread male PVC adapter into pump...
  • Page 5 STARTING PUMP - S33A (AUTOMATIC) 1. These pumps have an integral mechanical (mercury-free) ball float switch as shown on installation drawing. “Vertical switch” models have a vertical actuated cylinder float. 2. Plug cord into a 115 volt GROUNDED RECEPTACLE. 3. Run water into sump until pump starts. 4.
  • Page 6: Service Chart

    Service Chart SYMPTOMS Pump does not run or hum. Pump runs but does not deliver water. Pump runs and pumps out sump but does not stop. Pump runs but delivers only small amount of water. Fuse blows or circuit breaker trips when pump starts. Motor runs for short time then stops.
  • Page 7: Warranty Period

    MYERS LIMITED WARRANTY SUMP & RESIDENTIAL SEWAGE During the time periods and subject to the conditions hereinafter set forth, F.E. Myers will repair or replace to the original user or consumer any portion of your new MYERS product which proves defective due to defective materials or workmanship of MYERS. Contact your nearest Authorized MYERS Dealer for warranty service.

This manual is also suitable for:

S33S33v1S33v1cS33a1S33a1cS33p1 ... Show all

Table of Contents