HIS -ML12-Series D User Manual page 8

Installation Instructions
If the CD does not automatically run, browse the contents of the CD and
open the READ�ME�FIRST�htm file in a web browser� Select the appropriate
driver�
2� Click to "Run" the software when prompted� Follow on-screen instructions to
download and execute the touch screen driver installation�
3� A cable retention clip comes installed on the USB port on the rear of the monitor and
will help to secure the cable and ensure adequate strain relief� Without removing the
clip, route one end of the USB cable through the retention clip and connect it to the
USB input port on the monitor� Connect the other end to the USB port on the host
computer�
Serial (RS-232) Connection
1� Connect one end of the Serial cable to the Serial input port on the rear of the monitor�
Connect the other end to the Serial port on the host computer� Tighten the captive
screws on the cable connectors to ensure adequate strain relief�
2� Select the appropriate driver for your operating system�
a� If downloading from the web address listed above, select the appropriate
driver for your operating system�
b� If using the included CD, insert it into the host computer's CD-ROM drive�
If the CD does not automatically run, browse the contents of the CD and
open the READ�ME�FIRST�htm file in a web browser� Select the appropriate
driver�
3� Click to "Run" the software when prompted� Follow on-screen instructions to
download and execute the touch screen driver installation�
Calibrate the Touch Screen
Once the driver has finished installing, you are ready to calibrate the touch screen�
Open the touch screen's Control Panel by clicking on the "Elo Touchscreen" icon,
located in the host computer's Control Panel� Under the "General" tab, click the
"Align" button to start the calibration routine�
ML12D User Manual, January 2015
8