Using A Master Clock - DCS Rossini Transport User Manual

dCS Rossini Transport User Manual

Using a Master Clock

The performance can be improved further by adding a Rossini Master Clock to the system.
Analogue
outputs
to Amplifier
• Use the DAC's
• Connect the Clock's
• Connect the Clock's
The Transport will lock to the Word Clock and display this icon.
Set the DAC's
system to re-lock.
The "Bad clock" icon indicates that the Transport is receiving word clock at a frequency
other than 44.1, 88.2 or 176.4kHz and it cannot lock to it.
• If you intend to use other sources with the DAC, connect the Clock's
Clock In2.
• Make sure that the Clock is mechanically isolated from the other units, especially from the
Transport.
Proceed to Step 3.
Rossini Transport Manual v1_0x
Figure 3 – Using the Rossini Transport, DAC and Clock together
Input
button to select the input you want to use
Output 1
to the DAC's Word Clock In1.
Output 3
to the Transport's
Settings > Sync Mode
(AES1+2
Word Clock Input.
menu page to Word Clock In1
Page 13
Software Issue 1.0x
September 2018
in the example).
and allow the
Output 2 Word
to the DAC's
English version