Sample Safety Pilot Deployment Configuration - Savari STREETWAVE User Manual


Store and Repeat active message configuration contains message scheduling
parameters and message contents. (As per USDOT Req 4.1)
6.6

Sample Safety Pilot Deployment configuration

StreetWAVE™ radio configuration is very flexible. Any or both radios can be configured on any
channel in channel switching or continuous mode. Any sub-system (Store and Repeat,
Immediate Forward, and IPv6 provider) can be configured to use any of the two interfaces.
However, channel mode, channel numbers, and DSRC radios between all sub-systems should
be consistent on a given StreetWAVE™ unit.
The following is the recommended configuration:

Store and Repeat and IPv6 run on Radio 1, channel-switching mode between control
channel 178 and any service channel (except 172/178). Store and Repeat transmits on
configured channel (182 default) in ActiveDB files and IPv6 runs on control channel.

Immediate Forward, Immediate Forward, applications run on service channel 182 on
Radio 2, which is in continuous channel mode.
One of the StreetWAVE™ units can be configured as a UDP streaming unit. This is called Hub
StreetWAVE™. Other StreetWAVE™ units can be configured as stream receivers and are
called spoke StreetWAVE™. However, if antennas are disconnected, these messages will not
reach OBEs. The Hub unit can also be one of the units on the pole. In either case, it requires
Ethernet connectivity to the cabinet. All spoke units also should have Ethernet connectivity to
the cabinet.
A sample safety pilot multi-unit deployment configuration is illustrated in Error! Reference
source not found. with salient configuration parameters. Only important parameters are shown
below for illustration. Those parameters that are not shown here should be left at defaults for
this configuration.
Savari Inc., Confidential
Copyright © Savari, Inc, 2017
RSU2 User Guide