Table of Contents
Advertisement
5.4.8
NTCP client
Here we configure the host name to get the time synchronization when the GPS fix is absent.
The following parameters are displayed in the NTP app status command:
Figure 9: Ntpclient
5.4.9
RTCM
RTCM message used to get from the NOVATEL receiver on configured incoming IFM port.
The following parameters are displayed in the RTCM app status command:
Figure 10: RTCM
5.5
System Status
The operating mode of the StreetWAVE™ is also displayed. The operating mode could be any
of the following:
Hub:
Store and Repeat and Immediate Forward applications can be enabled in Hub
mode. Any of the applications Store and Repeat, Immediate Forward, can also be
individually configured in Hub mode.
Spoke: In spoke mode, Spoke StreetWAVE
Immediate Forward messages from Hub StreetWAVE
Note: To revive Store and Repeat and Immediate Forward messages in Spoke StreetWAVE
from the Hub StreetWAVE
If configured in Hub or Spoke, the appropriate mode will be displayed as 'enabled'. Both
modes are mutually exclusive in that an StreetWAVE™ can either be Hub, Spoke, or in a
streaming disabled mode (where neither Hub nor Spoke mode is enabled.).
Savari Inc., Confidential
Copyright © Savari, Inc, 2017
TM,
the applications have to be activated.
RSU2 User Guide
TM
will receive Store and Repeat and
TM
.
TM
Advertisement
Table of Contents
