System State - Savari STREETWAVE User Manual

IPv4 traffic from TCID to StreetWAVE™.

Incoming IPv4 and IPv6 inter StreetWAVE™ UDP streaming traffic on port 51015: Inter
StreetWAVE™ UDP streaming traffic.

Incoming TCP over IPv6 or IPv4 traffic on eth0 to ports 51012 (ssh, scp) and 8080(web)
of StreetWAVE™: Management access.

Incoming UDP over IPv6 or IPv4 traffic on eth0 to port 3334 of StreetWAVE:

All ICMPv6 and ICMP (v4) packets: StreetWAVE™ learning neighbors and vice versa.

All StreetWAVE™ originated outgoing traffic.
5.3

System State

StreetWAVE™ is in following two different states when powered on:

Run: All applications (Store and Repeat, DSRC Message Forward, Immediate Forward,
and IPv6) have started up.
Note: The run command takes the system to run state.

Standby: All applications (Store and Repeat, DSRC Message Forward, Immediate
Forward, and IPv6) are shut down.
Note: The Standby
StreetWAVE™ automatically enters to run state after it is powered on. To cycle system state,
please use the standby
Caution: The system should be halted ("halt") before turning off power. Else, the TX/RX packet
logs and system log files in the "/nojournal/" directory might get corrupted.
Savari Inc., Confidential
Copyright © Savari, Inc, 2017
command takes the system to standby state.
command followed by the run command.
RSU2 User Guide