Putting the receiver into operation
CAUTION!
Mounting the rack
mount "ears"
12
Putting the receiver into operation
Preparing the receiver for use
Recommendations for optimum reception
To ensure optimum reception even under difficult conditions, we
recommend connecting remote antennas and, if necessary, using
antenna splitters (see "Accessories and spare parts" on page 52).
When rack-mounting the receiver, you can mount the supplied
antennas to the front of the rack by using an antenna front mount
kit. When mounting more than one receiver into a rack, you should
use remote antennas.
If you want to mount the receiver
Read the corresponding chapter on page 14.
If you want to set up the receiver
Read the next chapter.
Setting up the receiver on a flat surface
Risk of staining of furniture surfaces!
Some furniture surfaces have been treated with varnish, polish or
synthetics which might cause stains when they come into contact with
other synthetics. Despite a thorough testing of the synthetics used by us,
we cannot rule out the possibility of staining.
Do not place the receiver on delicate surfaces.
The rack mount "ears" are designed to help protect the operating
elements from damage or deformation, e.g. if the receiver is
dropped. Therefore, fasten the rack mount "ears", even if you do
not want to rack mount your receiver.
To fasten the rack mount "ears"
Unscrew and remove the two recessed head screws (M4x8) on each
side of the receiver (see left-hand diagram).
into a 19"
rack:
on a flat
surface:
: