Sennheiser evolution wireless ew 300 IEM G3 Instruction Manual page 24

Synchronizing the transmitter with a receiver
Network operation
using the WSM
Stereo Transmitter Stereo Transmitter
Stereo Transmitter Stereo Transmitter
Operation without
network
22
Synchronizing transmitters with receivers – multi-channel operation
In multi-channel operation, the transmitters are remote controlled via a PC running the
"Wireless Systems Manager" (WSM) software.
Advantages of controlling the transmitters via the
(WSM) software:
• Detailed overview of all transmission and receiving channels
• Remote control of all transmitters in the network
• Combination of transmitters of different frequency ranges (see page 4)
Connect your transmitters and your PC in a network (see page 12).
Switch your transmitters and your PC on.
Launch the "Wireless Systems
To set up your multi-channel system, proceed as described in the instruction manual of
the "Wireless Systems
Carry out the Easy Setup Sync
function (see page 15).
The frequencies of the selected frequency presets must be approved and legal in your
country (see above).
You can also freely select the frequencies and store these frequencies in the frequency banks
"U1" to "U6".
If you want to use the frequency banks "U1" to "U6":
Make sure to use transmitters and receivers from the same frequency range (see page 4
and the type plates of the devices).
Only use frequencies that are approved and legal in your country (see page 21).
To ensure that the desired frequencies are intermodulation-free:
Contact your Sennheiser partner (see www.sennheiser.com).
Set each transmitter to the same frequency bank.
On one of the transmitters, select a channel within this frequency bank (see page 20).
Assign this channel one of the calculated transmission frequencies (see page 20).
Synchronize a receiver with your transmitter (
OR
Manually set the receiver to the same frequency bank, channel and frequency that you
set on the transmitter.
Repeat for the remaining transmitters and receivers as described above.
Manager" (WSM) software.
Manager" (WSM) software.
function and then, for each transmission link, the
"Wireless Systems
, see page 15).
Manager"
Sync