JVC HR-XVC1U User Manual page 17

Connect to a Stereo Amplifier with Audio Output
NOTE: If your TV has COMPONENT VIDEO IN jack, you can connect the DVD/VCR to the TV with a COMPONENT
cable (not supplied) as shown below. COMPONENT VIDEO output jack can send high-quality video signal to a TV
than S-Video Input.
Audio (R) Output
DVD
FRONT
R
L
SCART Æ PRISE PERITEL
TV-RGB-Composite
A/V-IN
Audio (L)
Video Output
Output
Connect to an AV Amplifier with built-in digital surround
If you are using an Amplifier with a built-in digital surround as follows, you can enjoy the various audio systems
such as Dolby Digital and DTS by using the Optical or Coaxial Digital Output.
Use this connection to connect an:
• AV amplifier with built-in *Dolby Digital decoder
• AV amplifier with built-in *DTS decoder
DVD/VCR
OUTPUT Æ SORTIE Æ AUSGANG
SCART Æ PRISE PERITEL DIGITAL AUDIO
AUDIO
R (D)
A/V-RGB-Composite
L (G)
Coaxial digital cable (not supplied)
Optical digital cable (not supplied)
Connecting the optical digital cable
You may connect to an AV Amplifier with an Optical digital cable (not supplied) instead of a Coaxial digital
cable.
•
When you connect the optical digital cable (not supplied), remove the dust protection cap from the rear of DVD.
•
When not using the optical digital cable, attach the dust protection cap to protect against dust.
NOTE:
• When you make the connections above, do not set DOLBY DIGITAL to DOLBY DIGITAL or DTS to ON on the AV
Amplifier. If you do, a loud noise will suddenly come out from the speakers, affecting your ears or causing the
speakers to be damaged.
• Caution for the optical digital audio output connector: Do not connect to an amplifier (with an optical digital input
connector) which does not contain a Dolby Digital, DTS or MPEG decoder. Otherwise, any attempt to play DVDs
may cause such a high level of noise that it may be harmful to your ears and damage your speakers.
DTS audio will be output only from the COAXIAL or OPTICAL output. To hear DTS audio, DTS-Decoder is
•
necessary.
When playing DTS-encoded CDs, only noise will be heard from the speakers or analogue stereo outputs.
•
• Some DTS decoders which do not support DVD-DTS interface may not work properly with the unit.
VIDEO Cord (not supplied)
OUTPUT
SURROUND
CENTER
SUB WOOFER
DIGITAL AUDIO VIDEO
AUDIO
R
L
To Audio (R) Input
AUDIO Cord (not supplied)
S-Video cord (not supplied)
VIDEO
Playback Connection
Amplifier
To Audio (L) Input
AV Amplifier with built-
in various decoder as
above
To Video
Input
TV
To S-Video Input
TV
NOTE:
You may connect to a TV
with a Component video
cable(not supplied) or S-
Video cable(not supplied)
instead of a video cable(not
supplied).
17