Dust And Drip Proof; Vibration Strength (Without Packing); Vibration Strength (In Individual Packing); Drop Impact Strength (Without Packaging) - Opticon OPH-5000i Specification Manual

9.4 Dust and Drip Proof

IEC IP54 equivalent
Protection against solid objects: Level 5 equivalent (Dust proof type)
Prevent dust ingress to inside. Even if slight dust intrusion will not inhibit normal operation.
Protection against liquids: Level 4 equivalent (Splash proof type)
Protected against water splash from any direction.
* () is JIS drip-proof type.
9.5 Vibration Tolerance (without packing)
There shall be no malfunction after the following vibration test.
Vibration test: Increase the frequency of the vibration from 10Hz to 100Hz at an acceleration
2
velocity of 19.6m/s
Repeat this of each X, Y and Z direction.
9.6 Vibration Tolerance (in individual packing)
There shall be no malfunction after the following vibration test.
Vibration test: Increase the frequency of the vibration from 10Hz to 100Hz at an accelerattion
velocity of 19.6 m/s
Repeat this of each X, Y and Z direction.
9.7 Drop Impact Tolerance (without packaging)
There shall be no malfunction after the following drop test.
Drop test: Drop the scanner 18 times in total (3 times at each 6 face), from a height of 150 cm
onto a concrete floor as shown below.
(2.0 G) for 30 minutes (60 minutes per cycle) in the non-operating state.
2
(2.0 G) for 30 minutes (60 minutes per cycle) in individually packaged state.

Figure 10: Drop Test

OPH-5000i
150cm
1st
24