Advertisement
Symbol Descriptions
The CE mark and Notified Body
Registration Numbers, the
requirement of Annex II from Medical
Device Directive 93/42/EEC are met.
Caution
BF type applied part
Classification for water ingress and
IP22
particulate matter.
Guidance and manufacturer's declaration – electromagnetic emissions
The TH5xy series is intended for use in the electromagnetic environment specified below. The customer or the user of the TH5xy series should
assure that it is used in such an environment.
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
Guidance and manufacturer's declaration – electromagnetic immunity
The TH5xy series is intended for use in the electromagnetic environment specified below. The customer or the user of the TH5xy series should
assure that it is used in such an environment.
Immunity test
IEC 60601 test level
Conducted RF
3 Vrms
IEC 61000-4-6
150 kHz to 80 MHz
Radiated RF
3 V/m
IEC 61000-4-3
80 MHz to 2,5 GHz
NOTE 1 At 80 MHz and 800 MHz, the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption
and reflection from structures, objects and people.
Indicates this device is subject to the Waste
Electrical and Electronic
Equipment Directive in the European Union.
To protect the environment, dispose of
useless device at appropriate collection sites
according to national or local regulations.
Please read the instructions for use
Battery Recycling
Stand-by
Compliance
The TH5xy series uses RF energy only for its internal function. Therefore, its RF
Group 1
emissions are very low and are not likely to cause any interference in nearby electronic
equipment.
Class B
The TH5xy series is suitable for use in all establishments, including domestic
Not applicable
establishments and those directly connected to the public low-voltage power supply
network that supplies buildings used for domestic purposes.
Not applicable
Compliance
level
Portable and mobile RF communications equipment should be used no closer to any
part of the TH5xy series, including cables, than the recommended separation
distance calculated from the equation applicable to the frequency of the transmitter.
Recommended separation distance
d = 1,2
d = 1,2
Not
applicable
d = 2,3
where P is the maximum output power rating of the transmitter in watts (W) according
to the transmitter manufacturer and d is the recommended separation distance in
meters (m).
3 V/m
Field strengths from fixed RF transmitters, as determined by an electromagnetic site
survey, a should be less than the compliance level in each frequency range b.
Interference may occur in the vicinity of equipment marked with the following symbol:
Electromagnetic environment – guidance
Electromagnetic environment – guidance
80 MHz to 800 MHz
800 MHz to 2,5 GHz
Authorized
representative in the
European community
Manufacturer
Paper Recycling
Advertisement
