Extending The Arm Bracket (In); Attaching Adjusting Block (D) - Hitachi HAS-WM06 User Manual

2 Loosen the fastening screw (in the location indicated by the arrow in the
diagram below) and extend the arm bracket (IN). Attach the adjustment block
(D) to the arm bracket (IN).
Adjusting block (D)
3 Attach the adjustment block (D) to the arm bracket with four M4 x8mm
hex-head screws (J). Align with the projection screen size and attach to the
position as indicated in the diagram.
M4 × 8 hexagon head
screws (J) (Four places)
Adjusting block (D)
*Far side of arm bracket (IN)
Projection screens 70 inches or larger but less
than 80 inches.
Note:
Face the knobs of the adjustment block (D) in the
directions shown in this diagram.
Arm bracket (IN)
Assemble the adjusting block (D) according to projection screen size.
HAS-WM06
Arm bracket (IN)
M4 × 8 hexagon head
screws (J) (Four places)
Adjusting block (D)
*Near side of arm bracket (IN)
Projection screens 80 inches or larger
CAUTION
8
Fastening screw
Arm bracket (IN)