Step 9 - Install Flue Hood - Bryant LEGACY 580J*16 Series Installation Instructions Manual

ECONOMIZER AND
HOOD SETUP, SIZE 16
NOTE: If the power exhaust accessory is to be installed on the
unit, the hood shipped with the unit will not be used and must be
discarded. Save the aluminum filter for use in the power exhaust
hood assembly.
1. The indoor coil access panel will be used as the top of the
hood. If the panel is still attached to the unit, remove the
screws along the sides and bottom of the panels. See Fig. 20.
2. Swing out indoor coil access panel and insert the hood sides
under the panel (hood top). Be careful not to lift the panel too
far as it might fall out. Use the screws provided to attach the
hood sides to the hood top. Use screws provided to attach the
hood sides to the unit. See Fig. 21.
3. Remove the shipping tape holding the economizer baromet-
ric relief damper in place (economizer only).
4. Insert the hood divider between the hood sides. See Fig. 21
and 22. Secure hood divider with 2 screws on each hood
side. The hood divider is also used as the bottom filter rack
for the aluminum filter.
INDOOR
COIL
ACCESS
PANEL
Fig. 20 — Indoor Coil Access Panel Relocation
(Size 16 Shown)
SCREW
LEFT
HOOD
SIDE
Fig. 21 — Economizer Hood Construction
(Size 16 Shown)
5. Open the filter clips which are located underneath the hood
top. Insert the aluminum filter into the bottom filter rack
(hood divider). Push the filter into position past the open
TWO-POSITION DAMPER
SIDE
PANEL
RAIN DEFLECTORS
TOP
PANEL
CAULK
HERE
INDOOR
COIL
ACCESS
PANEL
TOP
PANEL
INDOOR COIL
ACCESS PANEL
HOOD DIVIDER
filter clips. Close the filter clips to lock the filter into place.
See Fig. 22.
6. Caulk the ends of the joint between the unit top panel and the
hood top.
7. Replace the filter access panel.
DIVIDER
BAROMETRIC
RELIEF
Fig. 22 — Economizer Filter Installation (Size 16 Shown)
Step 9 — Install Flue Hood —
screwed to the basepan beside the burner compartment access
panel. Remove from shipping location and using screws provided,
install flue hood and screen in location shown in Fig. 23 for size
08-14 and Fig. 24 for size 16.
Fig. 23 — Flue Hood Details (Sizes 08-14)
Fig. 24 — Flue Hood Details (Size 16)
20
OUTSIDE
AIR
HOOD
CLEANABLE
ALUMINUM
FILTER
FILTER
Flue hood is
BLOWER
ACCESS
PANEL
CONTROL BOX
ACCESS PANEL
FLUE
HOOD
FILTER
CLIP
shipped