Kenmore 111.77106 Use & Care Manual page 4

IMPORTANT SAFETY INSTRUCTIONS
20. When moving the unit, make sure that it is in an upright position.
21. Keep the unit away from gasoline, flammable gas, stoves and other heat sources.
22. Don't disassemble, overhaul or modify the air conditioner, otherwise it will cause a
malfunction or possibly bring harm to persons and properties. To avoid hazard,
if a unit failure occurs, have the unit repaired before attempting to use it.
23. Do not install and use the air conditioning in the bathroom or other humid
environments.
24. Do not pull the plug to turn off the unit operation.
25. Do not place cups or other objects on the body to prevent water or other liquids
from spilling into the air conditioner.
26. Do not use insecticide sprays or other flammable substances near the air
conditioning.
27. Do not wipe or wash the air conditioner with chemical solvents such as gasoline
and alcohol. When you need to clean the air conditioner, you must disconnect
the power supply, and clean it with a half-wet soft cloth. If the unit is very dirty,
scrub with a mild detergent.
28. The appliance can be used by children aged from 8 years and above if they have
been given supervision or instruction concerning use of the appliance in a safe
way and understand the hazards involved.
29. This appliance is intended for indoor residential use only, not for industrial or
other commercial applications.
30. This appliance is intended for private household use only!
SAVE THESE INSTRUCTIONS
Power Plug
The power plug contains a device that senses damage to
the power cord.
To test the power cord:
1. Plug in the air conditioner. The plug has a Test and a
Reset button.
2. Press the TEST button and notice a click as the RESET
button pops out.
3. Press the RESET button. You will also hear a click as the
RESET button engages.
4. The power cord will now supply electricity to the unit.
5. Always make sure the RESET button in pushed in for
correct operation. The power cord must be replaced if
it fails to reset after this test.
Page 4
RESET
TEST