Step 12 Connecting The Power And Communication Cables - Samsung AM***NN1DCH series Installation Manual

Installation Procedure
Step 12 Connecting the power and
communication cables
Power and communication cable connection
• Before wiring work, you must turn off all power source.
• Connect the power and communication cable among
the units within maximum length to set the voltage
drop under 10%.
• The auxiliary circuit breaker (ELCB, MCCB, ELB) should
be considered more capacity if many indoor units are
connected from one breaker.
• Connect F3, F4(for communication) to the
communication cable of the wired remote control.
• Tighten the electric wires with a proper tool within the
torque limit to connect and fix them firmly, and then
organize the wires to prevent outside pressure being
exerted on the covers and other parts. Failure to do so
may result in overheating, electric shock, and fire.
M3.5 0.8 to 1.2
M4 1.2 to 1.8
Outdoor Unit
208-230V
ELB
MCCB
Indoor Unit 1
ELB : Essential Installation
16
English
• To protect the product from water and possible shock,
• Connect the power cable to the auxiliary circuit
• Keep distances of 50 mm (1-15/16 inch) or more
• Power supply cords of parts of appliances for outdoor
• Screws on terminal block must not be unscrewed with
• When installing the indoor unit in a computer room,
Tightening torque
lbf.ft
0.59 to 0.89
0.89 to 1.1
Indoor Unit 2 Indoor Unit 3
you should keep the power and the communication
cables of the indoor and outdoor units in the iron pipe.
breaker (ELCB, MCCB, ELB).
between power cable and communication cables.
use shall not be lighter than polychloroprene sheathed
flexible cord. (Code designation IEC:60245 IEC 57 /
CENELEC: H05RN-F or IEC:60245 IEC 66 / CENELEC:
H07RN-F)
the torque less than 12 kgf•cm (0.87 lbf·ft).
use the double shielded (tape aluminum / polyester
braid + copper) cable of FROHH2R type.
Wired Remote
Control
Indoor Unit 5
Indoor Unit 4
Ceiling, wall-mounted indoor unit.
EEV kit
Indoor Unit 6