Hauff-Technik HSI 150 Installation Instructions

Always. Reliable. Tight.
Installation Instructions
HSI 150 (cable entry system KES-M150)
Sleeve method KES-M150-D/ -KVB/ -HTV/ -D 3/58(-D 7/33).
Any national regulations regarding the laying and backfilling of pipework must be followed.
• Pack the foundations and cable support well before laying the duct in order to prevent the system from sinking.
• The incorrect laying of cable or ducts and improper filling of the cable trench causes settlement, which can cause damage and leaks.
• Cable entries should only be opened just before fitting with cables to avoid accidental damage during shell construction work.
• The entry must not be stressed mechanically by cables or pipes.
• Do not use solvent-based cleaning agents to clean the cable entries! (we recommend using Hauff cable cleaner KR M.T.X.).
• For further accessories and information see our website www.hauff-technik.de and our technical data sheets.
General processing advice:
• Minimum installation temperature of the rubber sleeves up to + 5° C, preheat system if necessary.
• Duct connection must not be stressed with tractive and compressive forces.
• Rubber sleeves and spiral hose must not be greased.
• The end of the spiral hose must be cut to length at right angles, clean and free of sharp edges or burrs.
Open closing cover
1
Key receptacle
2
Installing system cover
Preparation of variant -D
3
2.
Detail
3a
1.
Detail
3b
Limit stop
Remove protective foil if applicable (after warming slightly). Open closing
cover with the SLS 6G flexible head spanner (accessory) or with SLS 6G(D)
(accessory) if fitted with perimeter insulation via the wrench receptacles
with a twist to the left.
If necessary, clean out concrete residue from the wrench receptacles on
the black closing cover.
• Do not knock the closing cover in with a hammer or sharp object!
• Before mounting the system cover in the wall insert, clean the
interior of dirt and check the sealing faces for damage.
Insert the pre-assembled system cover with a slight twist into the ba-
yonet of the wall insert and screw in tight clockwise to limit stop (red
union nut must not be tightened at this point).
Check final position by matching the marker arrows on the wall in-
sert with the arrows on the system cover.
The red union nut is then tightened clockwise by hand or with the
SLS 6G(D) flexible head spanner until flush with the wall insert.
• Unneeded cable entries can be used as pressure-sealed back-up entries
as long as the Hauff quality seal on the closing cover is undamaged.
• We recommend fitting existing open cable entries, which are to
be used as back-up entries, with new HSI 150-D closing covers
and not to reuse the removed or possibly damaged closing cover.
Hateflex spiral hose 14150
Then insert the rubber sleeve onto the spiral hose 14150 up to the limit
stop (1.) and tighten the clamp using a A/F 13/10 Nm torque spanner.
Then push the hose with the mounted sleeve onto the head nozzle up
to the limit stop (2.) and tighten clamping strap using a A/F 13/10 Nm
torque spanner.
Hateflex spiral hose 14125
Push the sleeve with the small opening side, loose, approx. 50 cm wide,
over the Hateflex spiral hose 14125 (1.).
Then push the spiral hose approx. 4-5 cm (up to the limit stop) into the
system cover (2.). Push the sleeve onto the pre-mounted head nozzle
up to the red clamping nut and tighten both clamping straps using a
A/F 13/10 Nm torque spanner.
EN