Related Manuals for Kleton Standard MJ484
Summary of Contents for Kleton Standard MJ484
- Page 1 Instruction Manual Standard (MJ484-MJ489 & ML372) and Heavy Duty (MJ490-MJ495 and ML373) Hydraulic Hand Pallet Truck 9008-08/29/07...
- Page 2 WARNING! • Read and understand the entire operator’s manual before using the pallet truck. • Don’t load pallet truck beyond rated capacity of 5,500 lbs. for the standard models and 6,600 lbs. for heavy-duty models. • Secure load before transporting. • Keep the load centered on the pallet. • Don’t operate loaded pallet truck on ramps or inclines. • Always wear appropriate safety shoes. • Never leave a loaded pallet truck unattended in the raised position; always lower load to the floor. PALLET TRUCK ASSEMBLY Note: Individual trucks are assembled and ready to use. Pallet trucks purchased in crate quantities (6 units to a crate) require some assembly. Tools needed for assembly: hammer, flat screwdriver, 14mm wrench To attach handle assembly to the frame: *** IMPORTANT - SAFETY ***...
- Page 3 *** IMPORTANT - CHAIN**** Make sure that handle pin is Before this step, make sure to completely through the handle feed the chain on the outside and resting on the other side. of the piston stem roller (see yellow arrow). If left in its proper position, it will not be possible to insert the handle pin and chain, breakage may occur.
- Page 4 OPERATING PALLET TRUCK To raise the forks, place handle lever in UP position (bottom part of the handle slot). See Figure 2. DOWN NEUTRAL Figure 2 To lower forks, pull lever to DOWN position (upper part of the slot). To freely move the handle, set the lever in NEUTRAL (center notch of the slot). To lift a load: 1.
- Page 5 TECHNICAL PARAMETER Standard Heavy -Duty Model No. MJ484 MJ485 MJ486 MJ487 MJ488 MJ489 ML372 MJ490 MJ491 MJ492 MJ493 MJ494 MJ495 ML373 5500 lbs. 6600 lbs. Capacity 2500 kg 3000 kg H - Maximum 7 1/2" 7 1/2" Raised 190 mm 190 mm Height 3"...
-
Page 6: Troubleshooting
TROUBLESHOOTING Possible problems could arise in the operation of your hydraulic pallet truck. Their probable cause(s) and corrective action(s) follow: Condition Probable Causes Corrective Action Oil low in tank Make sure there is no till leakage from valve and add oil. Relief valve not seated properly or air in the See “Cleaning Relief Valve"... - Page 7 HYDRAULIC HAND PALLET TRUCK ASSEMBLY...
- Page 8 Parts list for Standard and Heavy-Duty Models Order No. Description Order No. Description MJ552 Handle MJ600 Main Lift Piston MJ553 Spring Pin 4x30 MJ613 Lock-Nut MJ554 Blocking Spring MJ614 Guide Roller MJ555 Spring Pin 4x20 MJ615 Bolt MJ556 Roller MJ616 19"...
Need help?
Do you have a question about the Standard MJ484 and is the answer not in the manual?
Questions and answers