HAMPTON BAY 42010 Use And Care Manual page 14

Assembly - Hanging the Fan (continued)
9
Mounting the fan-motor assembly
(close-to-ceiling mount)
WARNING: The locking slots of ceiling canopy are provided only
as an aid to mounting. Do not leave the fan assembly unattended
until all four canopy screws are engaged and firmly tightened.
Carefully unhook the fan from the mounting bracket (A) and
align the locking slots of the ceiling canopy (C) with the two
screws in the mounting bracket (A). Push up to engage the
slots and turn clockwise to lock in place. Immediately tighten
the two mounting screws firmly.
Install the two mounting screws (saved from Assembly Step
1 "Prepairing for mounting" into the holes in the canopy (C)
and tighten firmly.
Install the decorative canopy ring (M) by aligning the ring's
slots with the screws in the canopy (C). Rotate the ring
clockwise to lock in place.
You may now proceed to attaching the fan blades.
Assembly - Attaching the Fan Blades
1
Attaching the blade brackets to
the motor
WARNING: Remove the rubber motor stops on the bottom of the
fan before installing the blades or testing the motor.
NOTE: Your fan features revolutionary advancements for quick and
easy blade installation. Including an alignment post and captive
blade bracket screws.
NOTE: Your fan blades are reversible. Select the blade side finish
which best accentuates your decor.
Please note the captive blade bracket screws, are pre-
attached into the blade bracket (H).
Fasten the blade bracket (H) to the motor (E) by inserting the
alignment post into the slot on the bottom of the fan-motor
assembly (E) and tightening the motor screws.
Repeat for the remaining four blade brackets (H).
14
A
M
C
E
E
H