Maico WR 410 Quick Start Manual page 16

the temperature curve in the selected time
segment for the stated living area. Set the
desired room temperature* here.
* Setpoint temperature can only be set if auxiliary heat-
ing is connected.
Here you can see the air temperatures meas-
ured in the ventilation unit.
7.4 Humidity
The overview graph shows the air humidity
measured in the exhaust air and its course.
Set the desired humidity range to suit your
physical comfort here.
A dehumidification of the living areas takes
place if the maximum value is exceeded ‒
the ventilation unit switches to intensive
ventilation. In the case of unsuitable outside
air that is too humid (summer storms), the
intelligent control deactivates the dehumidi-
fication through intensive ventilation.
16
7.5 Sensors (optional)
You can see instantly whether the air quality
in certain rooms is optimum or not. The air
quality per time interval can be seen in the
overview graph. When Auto Sensor operation
is activated, the ventilation unit adapts its
volumetric flow depending on the air quality.
But you can also intervene manually and
adjust the ventilation level.
7.6 Air filter changes, cleaning, mainte-
nance
Imminent filter changes or maintenance work
are indicated on the operating units by sym-
bols or LEDs flashing  Chapter 15.
7.7 Faults
Faults are displayed on the operating units.
In the event of faults, contact your specialist
installer if need be  Chapter 14.