iCharger 1010B User Manual page 19

iCharger Synchronous Balance Charger/Discharger
Warning and error information
REVERSE POLARITY REVERSE POLARITY
REVERSE POLARITY REVERSE POLARITY
CHECK CHECK
CHECK CHECK
CONNECTION CONNECTION CONNECTION CONNECTION
BREAK DOWN BREAK DOWN
BREAK DOWN BREAK DOWN
SHORT ERROR SHORT ERROR SHORT ERROR SHORT ERROR
BREAK DOWN BREAK DOWN BREAK DOWN BREAK DOWN
INPUT VOLTAGE INPUT VOLTAGE
INPUT VOLTAGE INPUT VOLTAGE
LOW VOLTAGE LOW VOLTAGE LOW VOLTAGE LOW VOLTAGE
INPUT VOLTAGE INPUT VOLTAGE
INPUT VOLTAGE INPUT VOLTAGE
OVER VOLTAGE OVER VOLTAGE OVER VOLTAGE OVER VOLTAGE
BALANCE PORT BALANCE PORT BALANCE PORT BALANCE PORT
CELL LOW VOL CELL LOW VOL CELL LOW VOL CELL LOW VOL
BALANCE PORT BALANCE PORT
BALANCE PORT BALANCE PORT
CELL HIGH VOL CELL HIGH VOL
CELL HIGH CELL HIGH VOL
BALANCE PORT BALANCE PORT
BALANCE PORT BALANCE PORT
NOT CONNECT NOT CONNECT NOT CONNECT NOT CONNECT
BATTERY CHECK BATTERY CHECK BATTERY CHECK BATTERY CHECK
LOW VOLTAGE LOW VOLTAGE
LOW VOLTAGE LOW VOLTAGE
BATTERY CHECK BATTERY CHECK BATTERY CHECK BATTERY CHECK
OVER VOLTAGE OVER VOLTAGE
OVER VOLTAGE OVER VOLTAGE
Int. TEMP Int. TEMP Int. TEMP OVER Int. TEMP OVER OVER OVER
BREAK DOWN BREAK DOWN
BREAK DOWN BREAK DOWN
Ext Ext Ext. TEMP Ext . TEMP . TEMP OVER . TEMP OVER OVER OVER
BREAK DOWN BREAK DOWN BREAK DOWN BREAK DOWN
CAPACITY OVER CAPACITY OVER
CAPACITY OVER CAPACITY OVER
BREAK DOWN BREAK DOWN BREAK DOWN BREAK DOWN
SAFETY TIME OVER SAFETY TIME OVER
SAFETY TIME OVER SAFETY TIME OVER
BREAK DOWN BREAK DOWN BREAK DOWN BREAK DOWN
The output is connected to a battery with incorrect polarity
This will be displayed when an interruption of the connection between
battery and the charger output has been detected during charging or
discharging.
A short-circuit at output. Please check the charging leads.
The input voltage is below the limit set in the USER SET menu.
The input voltage is over the limit (18V).
The voltage of one of the cells in the Lithium battery pack is too low.
Please check the cell voltages one by one.
The voltage of one of the cells in the Lithium battery pack is too high.
Please check the cell voltages one by one.
VOL
In Balance charge mode, no battery is connected to the charger's balance
port.
Without using the balance port, the cell count detected by the charger is
less than that set by the user.
Please check the cell count of the battery pack.
Without using the balance port, the cell count detected by the charger is
higher than that set by the user.
Please check the cell count of the battery pack.
The internal temperature is over 65
The external temperature sensor detects (battery) temperature above the
limit.
The capacity (mAh) charged or discharged reached the configured
protection limit.
The charge or discharge time reached the configured protection limit.
( 149
℃
-19-
1010B/106B
o
F). Cool down the unit.