Advertisement
Documentation
Functions
Note
AK-LM 330 Vers. 1.4x
Go through the individual functions one by one and make the required settings. When settings have
been made for one controller, the set values may be used as a basis in the other controllers of the
same type and with the same software version. Copy the settings by using the copy settings function
in the AKM programme, and adjust subsequently any settings where there are deviations.
NB! If a list is required for noting down the individual settings, a printout can be made of it with
a function in the AKM programme. Read the next section, "Documentation".
Documentation of the settings of the individual controllers can be made with the print function in the
AKM programme. Select the controller for which documentation of the settings is required and select
the "Print Settings" function (cf. also the AKM Manual).
Shown below are function groups with corresponding measurements and settings. A printout of the
given settings can be made using the AKM function "Print Settings" (see above).
It has been necessary to make a selection from the numerous measurements and settings coming
from the controller.
There is not room for all these in the AKM programme controls.
It can display:
• 8 thermostats
• 2 pressostats
• 2 volt inputs
• 8 digital alarm inputs
• 2 consumption gauges
If it is necessary to obtain access to all measurements and settings, see Using Service Tool, type AK-ST
500.
Menu operation RC8CC202 © Danfoss 09/2012
3
Advertisement
